Laser Show Systems - Pinouts - MVM-S

This section contains pinouts of many popular boards and components that are used in laser show systems.
DISCLAIMER: The pinouts shown here were contributed by manufacturers, vendors and individuals. While every effort has been made to insure accuracy, LaserFX.com can not be responsible for any errors or omissions.

Pinout for the edge connector on the standard MVM driver cards [36 pin card edge connector] for 8 channel PCAOM. This is NOT an official MVM document - for the latest info, contact: msha1@aol.com

Mating edge connector is 0.156" spacing, 36 [18 X 2] positions - Digi-Key Part number EDC307360-ND or equivalent.

Pin Number	Signal description
3, 4, 7, 8, 11, 12	Ground
5 & 6	+15VDC @ 3/4 A Input
9, 10	RF output (to PCAOM cell)
13, 14	Blanking Input
15	Input Channel 1 (+)
16	Input Channel 1 (-)
17	Input Channel 2 (+)
18	Input Channel 2 (-)
19	Input Channel 3 (+)
20	Input Channel 3 (-)
21	Input Channel 4 (+)
22	Input Channel 4 (-)
23	Input Channel 5 (+)
24	Input Channel 5 (-)
25	Input Channel 6 (+)
26	Input Channel 6 (-)
27	Input Channel 7 (+)
28	Input Channel 7 (-)
29	Input Channel 8 (+)
30	Input Channel 8 (-)

1/ Any pins not listed above have no connection.
2/ To connect the channels in balanced mode, connect the positive (+) and negative (-) signals as indicated and tie the shield/common to ground.
3/ To connect the channels in unbalanced mode, connect the colour control signals to the positive (+) inputs only and tie the shield/common to ground.

DISCLAIMER: Some of the information in the Backstage area is provided by the persons or companies named on the relevant page(s). Laser F/X does NOT endorse or recommend any products/services and is NOT responsible for the technical accuracy of the information provided. We provide this information as a service to laserists using the Backstage area.