|
|
|
|
|
|
|
|
|
Home Page >>> Backstage Area >> Laser Show Systems > Pinouts |
 |
 |
 |
|
Laser Show Systems - Pinouts
This section contains pinouts of many popular boards
and components that are used in laser show systems.
MediaLas STP8 Actuator Pinout for the MediaLas STP8 Actuator. This is not an official MediaLas document, for the latest version, contact info@medialas.com Place the actuator on it's base with the mirror and arm pointing forward, and the circuit board with terminal strip at the bottom facing you. The terminal strip connections are:
Reverse actuation In some situations it is desirable to have the actuator's default condition be inserted into the beam, and the control signal cause it to move out of the beam. This is useful for color boxes and shutters. Caution, the STP8 us not spring loaded and if there is a problem, may not act safely as a shutter as it relies on power being applied to return to it's home [non activated] position. To reverse the direction of actuation, locate the yellow and black wires on the side of the circuit board. Carefully unsolder them and then re-solder them in reverse [yellow to black's original position - black to yellow's original position].
DISCLAIMER: Some of the information in the Backstage area is provided by the persons or companies named on the relevant page(s). Laser F/X does NOT endorse or recommend any products/services and is NOT responsible for the technical accuracy of the information provided. We provide this information as a service to laserists using the Backstage area.
[ Introduction - System Design - Scanning Systems - Support Equipment - Laser Graphics - Show Production - Pinouts ]
© 1996-2002
Laser
F/X International and LaserFX.com 905-523-7669 - All rights reserved. |
