Laser Show Systems - Pinouts - CL150

This section contains pinouts of many popular boards and components that are used in laser show systems.
DISCLAIMER: The pinouts shown here were contributed by manufacturers, vendors and individuals. While every effort has been made to insure accuracy, LaserFX.com can not be responsible for any errors or omissions.

Pinout for the card edge connector and on-board controls of the Laser Artistry CL-150 scan amp designed to drive G100PD, G120D and G120DT galvos at speeds up to 18K. This is NOT an official Laser Artistry document - for the latest info, contact Laser Artistry.

Pin Number	Signal description	G120D Pin
1	Optional ground
2	AC in from transformer
3	AC common - transformer center tap
4	AC in from Transformer
5	No connection
6	Velocity out
7	Position out
8	Scan signal input - balanced or unbalanced (+)
9	Scan signal input - balanced (-)
10	Scan signal input - common
11	Position detector input - red (+)	11
12	Position detector input - black (-)	3
13	Position detector - ground	4
14	AGC input	12
15	AGC out - oscillator drive	8
16	Oscillator common	13
17	Scanner drive high - red	1 and 9
18	Scanner drive low - yellow	2 and 10
19	Thermal blanket drive (see note 1)	7
20	Thermal blanket common (see note 1)	5
21	Thermistor (see note 1)	15
22	Ground

1/ Pins 19, 20 and 21 are indented for use with the G12DT galvo which has a thermal blanket for temperature control

Adjustment trimmers are provided on the card - see the card layout diagram for details

DISCLAIMER: Some of the information in the Backstage area is provided by the persons or companies named on the relevant page(s). Laser F/X does NOT endorse or recommend any products/services and is NOT responsible for the technical accuracy of the information provided. We provide this information as a service to laserists using the Backstage area.